Once in position around the vent it is secure, requiring
no screws or adhesives. The Ceiling Tile Saver can be installed
by in house personnel that have been certified to work on ladders
or other lifting platform.
The advantages of the Ceiling Tile Saver is that it eliminates the
need for constant ceiling tile cleaning. Cleaning can leave ceiling
tiles looking streaked or damaged. In the case of textured faced
tiles you will not lose the textured finish after each cleaning.
The Ceiling Tile Saver protects the investment and appearance of
your ceiling. The light reflectance of your ceiling will also be
maintained.
The Ceiling Tile Saver directs air flow down ward instead of out
across the ceiling. In the summer, cooled air is pushed past the
warm air layer pooled at the ceiling. Heated air, in the winter,
is directed downward where it is needed. The result is that climate
control is improved for your facility and the energy load on your
HVAC system is reduced.
Most importantly, when you open your facility up to the public,
your image will not be tarnished from the appearance of dust and
dirt.
Step by Step Installation
Instructions
1. Position the ceiling tile
protector ... around the ceiling vent. The smaller flange
should be flat and making contact with the vent or the
grid work.
2. Flex each side of the deflector
... into place by sliding the smaller flange between the
vent and the ceiling grid. Note: All four sides should rest against the grid
work and the small flange must be hidden under the grid
work.
3. Finished! The ceiling
tile protector should look like this on all sides, straight
down without any loose, hanging or bowed out sides.
